ben27

Dear Constabulary, thank you for your reply. I checked the number you shared and found a photo of the part online! If you happen to have this needle clamp that would great and I would be happy to buy it! And thank you for pointing out the missing 3 hole thread guide...Another search I think...Kind regards, Ben. I am based in the Netherlands btw.

Dear all, I now own a pfaff 26 - 2/01 - CSN8. It seems to missing part number 91-001 109-15. That is the clamp for the needle/ needle clamp. Can anybody point me in the right direction or help me to think of a functional alternative? Thank you very much in advance! Kind regards, Ben

I hope the picture helps. It is the plastic or bakelite knob that is broken (this image is from the net)

Hi All! I am trying to bring a pfaff 138 back to life. The bakelite dial is cracked and I would love to replace it with a fresher, intact dial. I cannot find anything online. Any help to point me in the right direction is appreciated!

Dear all, thank you for your answers. I ended up ordering a shorter V belt (97,5 cm) from optibelt. So no extra block to lower the servo. This was enough. It works a treat now!

Hi all! I just registered on the forum. I have a Pfaff 145 and just bought a servo motor. The v belt that I had is now too long. it is an optibelt 10x1060. I tried measuring with a string and ended up with 97-99 cm inner diameter. Is there a way to keep using this belt? And if not, what belt do you recommend? Any people with experience with this clutch to servo swap? Thanks a lot!