K1RB

Thanks for the links Jason. I'll take look at them when I get home.

Ok gotcha. So you have to make one larger and make one smaller in order to keep the same "footprint" size. I went off a 50/50 pattern that would mean the backside would be 20-30% larger than necessary. Makes sense. Part of me wonders if it may not be a bad idea to use a piece of wood and my wife's foodsaver to vac mold the front piece of leather and then stitch it to the back piece. Thanks for the links Jason. I'll take a look at them shortly.

That helps thanks. I figured if a 50/50 is half the width of the slide there might be a similar ratio for a 70/30 or 80/20. Baring that I was going to add an inch to one side and see how the gun pocket looked using some spring clamps I've read through your holster instructions and have made a pancake 50/50 for my SA Range Officer Compact off of them. Planning on trying a 1911 avenger and G19 soon. Hopefully the Glock is easier to wet mold. I sorta botched the 1911. It works but looks awful.

I want to take a shot at a flat back holster. How much larger do I need to make the front panel in order for this to work?