weekend

Thanks for the insight! I think I'm going to go ahead and clean and oil this thing and order the missing pieces, sounds like it should fit my needs just fine once it's up and running. Probably going to grab a section of butchers block counter top and fab up a table for it unless there's a better option.

Long time lurker first time poster! Never thought I would have the opportunity to get a machine but I was recently gifted an old singer 111W100. Laying some groundwork up front this is a first machine for me, I've always hand sewn, but I am willing to take on the project if only to learn and tinker. From what I am seeing in my first glance research I am missing, some obvious stuff like the a table motor, drive belt, pedal, the belt underneath that runs the walking foot? needle and probably some nuts and bits off the feed system on the top side of the head. So, is this a feasible project, are parts going to be a total nightmare, what am I really missing on this? Any insight or help would be appreciated, below I have attached some pictures of the machine hopefully I got that right.