Members YokoSama Posted Monday at 03:07 PM Members Report Posted Monday at 03:07 PM So when I measured my pattern for my fender I guess I made a mistake as I made it too wide and so now that im at the installation step I can not get it to lay flat, as it extends out over the edges and creates waves when I try. I think I have to trim this down on both sides to the inside of the stitching(aka good by all that hard work); but before I do that I was wondering if anyone had any better ideas? I also was going to use 3m tape to adhere it to the fender and not the pinion hole in the back Images are of the fender bib and of my bike fender. Thank you for the ideas/help! Quote
Members YokoSama Posted Tuesday at 08:34 PM Author Members Report Posted Tuesday at 08:34 PM (edited) I ended up just trimming it. No side stitching, using more glue to adhere the sued to the top leather and this is the final result. Edited yesterday at 03:02 PM by Northmount Fixed a couple typos Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.