Members hemiyota Posted Tuesday at 07:08 PM Members Report Posted Tuesday at 07:08 PM I was attempting to equalize the forward and reverse stitch length, as described in the video by Ewe. Got to the point where you move the block, to either lengthen or shorten the forward stitch, and it wont move. After loosening the screw, when I try to move it, it just moves the reverse lever. Isn't it supposed to pivot on the shaft? Quote
Contributing Member friquant Posted Tuesday at 07:45 PM Contributing Member Report Posted Tuesday at 07:45 PM Can you post a link to Uwe's video, and post photos of the block you're trying to move? Quote friquant. Like a frequent, piquant flyer. Check out my blog: Choosing a Motor for your Industrial Sewing Machine
Members hemiyota Posted Tuesday at 09:20 PM Author Members Report Posted Tuesday at 09:20 PM Here's the link to the video. Procedure starts at about 10:00. I'll post a pic in a bit... Quote
Members hemiyota Posted Tuesday at 10:32 PM Author Members Report Posted Tuesday at 10:32 PM Here's the part that should move, if I'm understanding the video correctly... Quote
Contributing Member friquant Posted Tuesday at 11:03 PM Contributing Member Report Posted Tuesday at 11:03 PM You could put a crescent wrench on the block to gently rotate it Quote friquant. Like a frequent, piquant flyer. Check out my blog: Choosing a Motor for your Industrial Sewing Machine
Members hemiyota Posted 1 hour ago Author Members Report Posted 1 hour ago I don't want to mess with it too much until I know, for sure, that it's supposed to move.... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.