iwannabeacowboy Report post Posted November 2, 2009 I just got the lube pot for the Boss, but can't figure out where to mount it. If someone has one can you post a picture to show how to mount it. Thanks Charlie Quote Share this post Link to post Share on other sites
dirtclod Report post Posted November 3, 2009 I don't know for sure where it goes, but generally they up on top of the machine in front of the thread spool. Weird they don't even show it on their site. Quote Share this post Link to post Share on other sites
Denster Report post Posted November 4, 2009 There are a couple of ways to mount it but the most convenient I found was to mount the end of the bracket on top of the thread stand by the bolt that connects the thread stand to the machine. You can then angle the pot so it is a direct shot to the first double hole thread guide. Quote Share this post Link to post Share on other sites
iwannabeacowboy Report post Posted November 5, 2009 Thanks, thats were I mounted it. But it dosen't look right. Also I had to file down the bracket to get it to fit on the screw for the thread holder. Charlie Quote Share this post Link to post Share on other sites
Denster Report post Posted November 5, 2009 Charlie Yeah I know itt doesn't look right but it works and that is whats important. I had to file my bracket also. It is a generic lube pot it isn't made by Tippmann or for Tippmann. Quote Share this post Link to post Share on other sites
