gregd Report post Posted October 4, 2010 Ive been trying to figure out how to make the holes under the leaf ridges... tried a seeder nope . Is there a special tool? Quote Share this post Link to post Share on other sites
Hilly Report post Posted October 4, 2010 Ive been trying to figure out how to make the holes under the leaf ridges... tried a seeder nope . Is there a special tool? You can use a lifter from Barry King Tools (6th row down, center photo). Well worth the money. Quote Share this post Link to post Share on other sites
dirtclod Report post Posted October 5, 2010 Here's a link showing one used. I made a couple out of scracth awls if you don't to buy one. Cut your awl on angle and the use a whet stone to smooth it up then polis it on a buffing wheel. http://leatherworker.net/forum/index.php?showtopic=9037&hl=clayb&st=0 Quote Share this post Link to post Share on other sites
King's X Report post Posted October 5, 2010 The tool is a petal lifter or lifter. Tandy has one that is a bit cheaper, but it will require some sharpening. Barry King does sell them, but at a higher cost depending on your level of crafting. I have a set of custom one that were made by Big Papa Leather on this forum! They are extremely sharp! Good luck. Quote Share this post Link to post Share on other sites
