1St Pancake

[George B]

In need of advice for improvement.

I realize I need more leather above and below the belt slots to reduce stretch and breakage but what else do you think I need to do?

This was made for a Springfield XD 40 cal 3.5" barrel.

[Reaper]

I like the forming and the color is nice also.

couple of things I wonder about..

I wonder if the weapon being angled back like it is will lend to it jumping out down the road if the carrier has to run or is the trigger guard meant to help retain it? Also about the trigger guard inner molding, is it so deep it will actually fire the weapon if it the striker is reset and the safety is off when put into the holster?

[George B]

I like the forming and the color is nice also.

couple of things I wonder about..

I wonder if the weapon being angled back like it is will lend to it jumping out down the road if the carrier has to run or is the trigger guard meant to help retain it? Also about the trigger guard inner molding, is it so deep it will actually fire the weapon if it the striker is reset and the safety is off when put into the holster?

The forming is tight enough that even with full clip it does not move when handled roughly, but that is a concern I will address in my next one.

I used 9-10 oz. skirting leather and the form for the trigger guard will not depress or if so very little when lots of pressure is applied, but once again it is something I will look at with my next. Thanks for the advice.

[Reaper]

I like it, reminds me of a Galco Belt Slide my brother carries his Sig 220 Carry in. I've worn his and I do like the fact that it isn't bulky at all.