zAZ90 Report post Posted February 6, 2013 I recently purchased an Artisan LS-1020 Splitter. I was wondering if anyone could give me any hints on how to strop the 20"+ blade. It is sharpened on both sides which makes it a bit unwieldy. I took the blade off this evening to check it since I've given the machine considerable use. It was still very sharp so I didn't mess with it for now. Would appreciate any help. I'm very pleased with the performance of the LS-1020 so far and will likely sell a couple of my crank splitters. The Artisan is very accurate and easy to use. Quote Share this post Link to post Share on other sites