alpenabbq Report post Posted February 21, 2013 Looking for a tool or method for edging an oblong punched slot in 2 plys of 8-9 oz, I've tried using a machinist deburr tool (Vargus, Noga), works great on the straight, but tears the leather when going around the radius. Any help or suggestions would be appreiated Quote Share this post Link to post Share on other sites
JustKate Report post Posted February 21, 2013 There are punches made for that purpose: Oblong punches Quote Share this post Link to post Share on other sites
gringobill Report post Posted February 21, 2013 Barry King makes an edger specifically for especially tight inside curves. It is a bissonet edger with a really tight curve. I use one for edging some punched slots. The bigger the slots the better it works, 3/4-1" in length. Quote Share this post Link to post Share on other sites
alpenabbq Report post Posted February 21, 2013 Thanks gringobill, I was not aware of this tool, I figured someone had figured out a solution. Quote Share this post Link to post Share on other sites
