Dast Report post Posted May 4, 2013 (edited) I'm having problems punching nice-looking holes in a strap - been using Osborne drive punch to make 1/8 inch holes in ~4mm leather. The holes look ok on the reverse side but on the punching side they are slightly enlarged and the edge is kind of rounded over. I can understand why this is happening due to the taper of the tool but in items I have seen (e.g. hand-made watch straps) the holes are the same on each side. How is this achieved? Edited May 4, 2013 by Dast Quote Share this post Link to post Share on other sites
tjlenox Report post Posted May 4, 2013 try punching the hole and then flipping the piece over and punching through the back side too Quote Share this post Link to post Share on other sites
