retiredff Report post Posted November 21, 2017 Hello, I read a post by someone here that said " To improve the impression of most Craftool stamps grind the hammering end flat". After looking at mine all of them are domed shaped. Has anyone tried this? Thanks Tony Quote Share this post Link to post Share on other sites
retiredff Report post Posted November 30, 2017 must be a tough question. Quote Share this post Link to post Share on other sites
sheathmaker Report post Posted November 30, 2017 Not a tough question at all for me. Any time I get a tool with a domed top I immediately grind it flat. I found out many years ago that a domed top is very susceptible to glancing mis-strikes and the results of that are usually not good.......so "Grind 'em if you got 'em. Paul Quote Share this post Link to post Share on other sites
retiredff Report post Posted November 30, 2017 You may have been the one that wrote the comment in post I asked about. I have some rusted tools I'll experiment with. Quote Share this post Link to post Share on other sites
