strathmoredesigns Report post Posted November 26, 2017 Question for folks that own Harbor Freight's 1 Ton Arbor Press: What is the distance between the bottom of the ram (not sure if this is the right word) and the top of the slotted steel plate? How tall is the steel plate? I'm interested in trying this with some taller stamps and I'm trying to figure out if there's enough room. Thanks! Quote Share this post Link to post Share on other sites
cradom Report post Posted November 26, 2017 From the top of the slotted plate to the part which holds the ram (the ram can go higher) is 4 3/4 inches. The plate is roughly 5/8in thick, not including the pin on the bottom that holds it in place. If you drill a hole deep enough in the ram, tool length shouldn't be much of a problem, unless it's a really long tool. Quote Share this post Link to post Share on other sites
strathmoredesigns Report post Posted November 26, 2017 Thanks, exactly what I was looking for! Quote Share this post Link to post Share on other sites
