Members mont49 Posted September 13, 2020 Members Report Posted September 13, 2020 (edited) I have a Juki 563 machine that I have replaced the lower drive shaft. Now I need to sync top shaft to it, and not sure how to do that. The procedure to sync top and bottom shaft uses the two lines on castimg with take up at highest position. But I have loosened all bushings . I need advice on how to complete sync. thanks, I am new to this forum, located in Oklahoma, I do a little work on boats and leather as a hobby. thanks Edited September 13, 2020 by mont49 Omitted some information Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.