Ozzjim Report post Posted April 12, 2015 Hi Folks, I bought a Dremel workstation; Drill press. It looks as if it will be great, BUT, there must be an item that didn't come with it for fitting around my Dremel I have been using. It looks as if the Dremel fits into a bracket and that bracket attaches to the workstation. I bought it on ebay, the guy hasn't responded to my 2 emails asking about it, Guess he is asking for a bad rating.. or maybe just out of touch. Any one have any ideas? I looked on the 'exploded view' no such bracket, looked on a Dremel motor assembly kit, none in there. I need help. Thanks. Ozzjim Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted April 12, 2015 (edited) @7:45 Edited April 12, 2015 by Tree Reaper Quote Share this post Link to post Share on other sites
jstar61 Report post Posted April 12, 2015 This may help. https://youtu.be/JyoHfz9pu3Q Quote Share this post Link to post Share on other sites
Ozzjim Report post Posted April 12, 2015 Well, I tried to post a link to the workstation, but for some reason it wouldn't take. I have a older Dremel that is listed on their site as a compatible motor Quote Share this post Link to post Share on other sites
Ozzjim Report post Posted April 12, 2015 Ahhh, a little Red-face on this end. Didn't know the darn thing had a removable collar... Thanks so much for the link to the Youtube. My wife probably thinks I am an idiot.. not far off I guess. Thanks again. Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted April 12, 2015 I had the same problem, same tool different attachment,I hadn't used it in a few years and just forgot how it worked. It happens to more than just a few of us I'm sure. Quote Share this post Link to post Share on other sites
