rickeyfro Report post Posted March 6, 2010 If you Sheridan style guys were to purchase one set of bargrounders from Barry King what size would you go with? Really hard to tell any difference from the catalog or websiite pics. Quote Share this post Link to post Share on other sites
D.A. Kabatoff Report post Posted March 6, 2010 Rickyfro, hard to say which size you should get... it really depends on the size of flowers you are carving. If you are carving small flower and using larger grounders, you'll have problems getting them into the tight corners where stickers converge with vines, etc... If your carving large flowers and using small grounders, you'll be backgrounding all day long. I'd say your best bet is to decide what diameter of flower you think you'll be carving the most and call Barry and get his opinion on it. Darcy Quote Share this post Link to post Share on other sites
hidepounder Report post Posted March 6, 2010 Darcy's right, Rickey, the size of the bar grounder is completely decided by the patten. Most recently I have been using a #25 set on my work and am going to try a #20 which I just bought in Wickenburg. These are the small side and are defintely harder to run than a #30 or #35, which are a little too large for my current patterns. Hope this helps... Bobby Quote Share this post Link to post Share on other sites
rickeyfro Report post Posted March 7, 2010 Thanks guys Quote Share this post Link to post Share on other sites
