MartyS Report post Posted September 13, 2010 Hi, Does anyone make a true sit stand pedestal. And if so, is it quick and easy to switch the controls, etc. Comments appreciated. Thanks Marty Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted September 19, 2010 What make & model of machine do you want to put on this stand? Bob Quote Share this post Link to post Share on other sites
MartyS Report post Posted September 21, 2010 cylinder arm 69 - 207 thread, servo... thanks, I need to stand sometimes as too much sitting is un-healthy for me. M What make & model of machine do you want to put on this stand? Bob Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted September 22, 2010 Marty, Here's a pic of our stand @ almost the highest the table top measures 44" & will go down a good 10".You would have to remove the bolts on the column & move them to different holes to go from sit to stand & adjust the chain for both the motor & foot lifter also. Bob Quote Share this post Link to post Share on other sites
