Ragnar

HI, I purchased a USM clicker press in fine working condition a few years ago. The seller lowered the swing arm to the table for transport. I wasn't there to see the process. Now I'm in the process of putting the machine into service, and I can't figure out how to raise the swing arm, prior to starting the machine. During storage there is some slight corrosion on the the vertical column. Thanks in advance Ragnar

We are looking for a source of clicker steel , so we can make clicker dies in house. Most steel rule die material is made for insertion into a die board, not thick enough for welded dies. Any thoughts are appreciated. Thanks