vaporlock

Good morning CHgehrig, I only have the 5/6 plate. since these plates are hard to get, I would recommend making a 7/8 plate from scratch. I'll see if I can find out the thickness of the 7/8 plate and post it here. Grüße vaporlock

Good afternoon, I am adding an SD28 to my toolbox and even though a lot has been written about this and the pedersen machine, I can not find which thread size corresponds with which needle size. the pedersen 308 manual states : use 6 strand twisted linen, waxed on the bobbin, unwaxed on the upper. needle #5 goes with thread #5, #6 with #6 etc. but these notations are from way before I was born and I have no idea which thread diameter goes with which number. Is it as simple as measuring the needle's blade and take the same diameter thread? Thanks in advance, friendly regards vaporlock