logohigh
-
Content Count
5 -
Joined
-
Last visited
Posts posted by logohigh
-
-
Turns out the nearside screw hole is fubared , screw just drops in .....other side is better Thankfully !
must taken a long time to get like that
i would naturally assumed the machine would be harder than the screw
-
im guessing at this point its not the machine screw thats the problem - damn
-
2 hours ago, Constabulary said:they just cost a few bucks - sample:
https://www.college-sewing.co.uk/9400000013-992003376-needle-plate-screw-adler-genuine.html
Most industrial sewing machine dealer should have them.
And it would not surprise me if they have the same threading as singer 111 needle plate screws but I´m not 100% sure
i bought these exact ( im in UK ) , they dont fit
- that was when i went to specialist nutn bolt store who have a great rep for getting what you want
Thanks all for replies !
-
Hi
hope this is right section
is there anything special about needleplate screws ..?
iv been to specialist nut n bolt shops but the ones come away with are either not the right thread - or possibly the thread they are going into is fubured ...
Either way. the head is too big .Should be 6mm
TIA
Duncan
( Sail/cover maker ).
Adler 167 Gk373
in Leather Sewing Machines
Posted · Report reply
The screws from college sew have a 7mm head which would leave them proud of the plate ...
perhaps they are for a non OE plate