Theworks001

I have a Juki 1508NH but it didn’t come with the knee lift attachment. After installing the attachment, I noticed the knee lift would only raise the feet about 4mm, although it would still drop the hand lift. I tried making a few adjustments on the bottom of the machine using the engineer’s manual. Now the knee lift goes up the same height as the hand lift (but I believe it should actually raise higher than the hand lift). The problem now is that the knee lift no longer drops the hand lift at all. Has anyone run into this issue before? Any guidance or suggestions would be much appreciated. IMG_7170.mov

All, I need some help identifying a sewing machine, preferably, a walking foot cylinder machine. The machine will mainly be used to see patches on hats but, I would like the option to start sewing dog harness. I believe 2 12/13oz leather pieces. I was looking into the cobra 26 but I’m not sure if it’ll sew through 2 12/13 oz leather. Any help will be appreciated

I’m trying to swap the needle system on my juki 1508nh to the 135x17 needle system. Could someone please provide me with some directions? Many thanks in advance