MonsieurHidan

Looks like man except from the top part of the male die... I got it and it looked already use I don't know it's not looking clean as yours.

Hello thanks for the reply ^^ My Leather is 3,2mm to 3,5 and the snaps are Line 24 from Tandy. I was able to put the female once... But the male won't work like i can't even press it with the machine.

@Dwight I'm gonna try that yeah but i need a bigger hammer ahah ! Sorry to hear about your neuropathy problems man i really hope it's not gonna get worse over time And for you @LeatherLegion can you tell me if every snaps dies pairing are good ? Male Female

Hello everyone! ^^ I recently delved into the world of leather crafting (since July) and have been experimenting with snaps. I purchased a hand press, but little did I know the challenges that awaited me. Despite acquiring the correct die, snaps, and presumably the right press (haha), I am at my wits' end trying to affix snaps to my belts. Each attempt either ends in a ruined snap or misalignment on the leather. To add to the woes, a die has now become lodged in the silver plates after an attempt to set a snap on the leather. It's quite bizarre. Would anyone have suggestions on how I could resolve this issue? Thank you! And some exemple of my First two project :