Search the Community
Showing results for tags 'billiards'.
Found 2 results
-
Spent my time stuck at home for the past few months on my first attempt at building a cue case. Most of the ideas are borrowed from the popular cue case makers, like Jack Justis and J. Flowers. I used Tochigi vegtan leather, and the colors are natural /mahogany. It was my first time doing a project this large, so it was pretty challenging, but it turned out pretty decent I think.
-
This is my first commission: It's a Wet formed, semi-rigid, saddle stitched, single cue case (1x1 or one butt, and one shaft). Came out looking sort of like a saddle scabbard, don't you think? Yes, that is a single run of stitching. I started half way (at the bottom), leaving half the thread hanging, stitched up to the mouth of the case, and finished there, then picked up the hanging thread, and stitched up to the mouth on the other side. It's only twelve feet of thread The inside is unfinished, with a deerskin sleeve for the shaft. The sleeve is stitched into the slimmer side of the case like a welt. It runs out the bottom as well, so there's no opening for chalk to get in with the butt. Shafts get chalk on them anyway, but the wraps on cue butts can be very hard to clean. In a related question: After all the sewing, I'm wondering how you figure price for that? Perhaps I'm slow, but considering this one, and the prototype, it takes about four hours to sew each one. Carey Leather Newb
- 23 replies