Search the Community

This is how I went about making my first heavy duty linesman's pouch.there have got to be easier ways but for now this is what I did. I got a call from a guy that wants his own pouch as he is left handed and also wants the tools to slide in easy and not fall out when upside down.Leather has to be waterproof and as thick as 3.6mm (9oz) to remain durable as possible.No problem!!??. First step buy a big Cowboy sewing machine and spend a day learning how to use it and find its capabilities. This resulted in knocking it out of timing as I found it could stitch OK going forward but would not pick up the bobbin thread going backward. A search on the net showed some videos on the subject but the best info I found was in a Juki engineers manual which gives clear measurements I found referenced in L.W. After getting in the right needle and thread (277-10metric used top and bottom) I proceeded to CAD out some patterns as shown below. Second pic shows leather cut out and bolted together to test pattern. Picture 3 shows back view. 4 shows the test hanging upside down works Pic 5 shows the outer third piece stitched to the second piece. Pic 6 shows stitching the outer stitched layers onto the back layer by sewing through and following the same holes and removing bolts on the run. Bit scary but all went well. Pic 7 shows the finished pouch with tools in and it tested good. Last pic shows the belt that is suede backed and measures 6mm (1/4") thick stitched here with a 230 size 26 LR needle except for the keeper. Any tips and criticisms are most welcome. Brian