Jump to content
Mrrattle

needle postion sensor instal on consew 206rb

Recommended Posts

just in case someone is looking for inspiration

this is how i installed needle position sensor on my consew 206rb-5.

there is an existing hole on the back of the machine. i bent a piece of aluminum flat bar as shown in the picture. 

with this setup i can tilt the machine back without worrying about the sensor, i can even take the belt off without disturbing the sensor at all.

install.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...