Mast Foot Press 11040

[Kat1234]

I have a Mast Foot Press #11040, by MAST Harness Hardware.  They are no longer in business.  There is a setup guide, and a list of dies.  Unfortunately, there is only one punch and no other parts.  Is it possible to get dies to fit?  There is an adapter listed that converts a 5/16" hole to a 3/8" hole, so I am assuming that we would need something to fit the 5/16 hole.  Obviously, I am not familiar with these pieces of equipment.  Does anyone have  suggestions for finding parts?

[kgg]

4 hours ago, Kat1234 said:

I have a Mast Foot Press #11040, by MAST Harness Hardware. 

If I'm not mistaken I think they were taken over by Weaver years ago. I would check with Weaver to see if there is anything available.

kgg

[Kat1234]

6 hours ago, kgg said:

If I'm not mistaken I think they were taken over by Weaver years ago. I would check with Weaver to see if there is anything available.

kgg

I will contact them.  Thanks

[bruce johnson]

My Mast press takes 3/8 dies. The Weaver Little Wonder hand presses I have sitting here take 3/8 dies also they should be pretty available. It looks like Weaver is only selling their Master Tools foot press now. Another source for dies is  Beilers in Ronks, PA. They still sell foot presses similar to yours, Amish business with no website but they send out catalogs. 

[Kat1234]

20 hours ago, bruce johnson said:

My Mast press takes 3/8 dies. The Weaver Little Wonder hand presses I have sitting here take 3/8 dies also they should be pretty available. It looks like Weaver is only selling their Master Tools foot press now. Another source for dies is  Beilers in Ronks, PA. They still sell foot presses similar to yours, Amish business with no website but they send out catalogs. 

Thanks! That is what I needed to know to make a start. I will start looking into these.  I didn't know if that size was something fairly standard.