Pneumatic foot lift for sewing machine

[Tigweldor]

Came from an Adler 167-8063 but with very minor mods will fit most any sewing machine.

Solid brass pneumatic cylinder and brass swivel mounting foot bracket mirror quality.

Stock 6 pole socket not needed - as in reality only 2 wires get through to the magnetic valve.

It uses a 24 Volt DC valve  - but I have had it in operation with only 12 Volt DC - it works fine.

Ran it on 3bar, which is around 40psi.

Meanwhile sold the 8063 - which could make 10mm long stitches and was left at that length - its´ only real highlight.

It was the twin needle version with 2 complete hook drive mechanisms - came from VW from their car seat manufacture in Kassel.

Had fitted it with a VFD though.

Asking 200€ plus shipping for the foot lift.

Edited yesterday at 03:22 PM by Tigweldor