Members Tigweldor Posted April 12 Members Report Posted April 12 (edited) Came from an Adler 167-8063 but with very minor mods will fit most any sewing machine. Solid brass pneumatic cylinder and brass swivel mounting foot bracket mirror quality. Stock 6 pole socket not needed - as in reality only 2 wires get through to the magnetic valve. It uses a 24 Volt DC valve - but I have had it in operation with only 12 Volt DC - it works fine. Ran it on 3bar, which is around 40psi. Meanwhile sold the 8063 - which could make 10mm long stitches and was left at that length - its´ only real highlight. It was the twin needle version with 2 complete hook drive mechanisms - came from VW from their car seat manufacture in Kassel. Had fitted it with a VFD though. Asking 200€ plus shipping for the foot lift. Edited April 12 by Tigweldor
Members Tigweldor Posted April 29 Author Members Report Posted April 29 Sold locally. Actually traded it for an older defect hot foil stamping machine. At home I found out that it just needs a new heating element - which comes to about 30€ Ad can thus be deleted. Greetings Hans
Recommended Posts