Landis 3 loop thrower or thread eye

[dozernmike]

I am looking for a landis 3 loop thrower. The little finger with a hole in it that moves the thread in front of the needle. I have tried the landis number for a few months but I'm not getting an answer. I thought I would see if anyone has one before attempting to make one out of a 5/32 aircraft drill bit.

[mbnaegle]

I think the Campbell one might interchange, if you change out the holder for it. I think it was all one "L" shaped piece on Randall's and Landis 3's, but the new 2 piece Campbell style interchanges with the Randall at least, and it gives a little more adjustment to get the eye just where you want it.

CHS-602 for the thread eye which is straight with a little bend on the eye end and is .124" diameter.

And CHS-593A for the holder which is .186 diameter on the vertical end, if you want to check it.

Edited June 20, 2025 by mbnaegle

[dozernmike]

That is helpful information. Thanks