Members Dlane Posted September 16 Members Report Posted September 16 Hi all it’s been a while, I bought a front hub ,shaft , gear from a place in England . The gear hole is .003 smaller than shaft , is it a shrink fit ?, there is no set screw on gear . Any advice on installing this and the front balance wheel would be appreciated thanks Quote
Contributing Member friquant Posted September 16 Contributing Member Report Posted September 16 Hi Diane, Sounds like a complex operation. How about posting several pictures of the parts you bought and the machine it's going into? Quote friquant. Like a frequent, piquant flyer. Check out my blog: Choosing a Motor for your Industrial Sewing Machine
Members Constabulary Posted September 18 Members Report Posted September 18 (edited) post some pictures. I once bought front shaft for my 29K71 restoration from College sewing in the UK and I remember the gear was very tight on the shaft but it worked. But I had the OEM gear. Edited September 18 by Constabulary Quote ~ Keep "OLD CAST IRON" alive - it´s worth it ~ Machines in use: - Singer 111G156 - Singer 307G2 - Singer 29K71 - Singer 212G141 - Singer 45D91 - Singer 132K6 - Singer 108W20 - Singer 51WSV2 - Singer 143W2
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.