Members Dlane Posted Tuesday at 03:38 PM Members Report Posted Tuesday at 03:38 PM Hi all it’s been a while, I bought a front hub ,shaft , gear from a place in England . The gear hole is .003 smaller than shaft , is it a shrink fit ?, there is no set screw on gear . Any advice on installing this and the front balance wheel would be appreciated thanks Quote
Contributing Member friquant Posted Tuesday at 05:08 PM Contributing Member Report Posted Tuesday at 05:08 PM Hi Diane, Sounds like a complex operation. How about posting several pictures of the parts you bought and the machine it's going into? Quote friquant. Like a frequent, piquant flyer. Check out my blog: Choosing a Motor for your Industrial Sewing Machine
Members Constabulary Posted 17 hours ago Members Report Posted 17 hours ago (edited) post some pictures. I once bought front shaft for my 29K71 restoration from College sewing in the UK and I remember the gear was very tight on the shaft but it worked. But I had the OEM gear. Edited 17 hours ago by Constabulary Quote ~ Keep "OLD CAST IRON" alive - it´s worth it ~ Machines in use: - Singer 111G156 - Singer 307G2 - Singer 29K71 - Singer 212G141 - Singer 45D91 - Singer 132K6 - Singer 108W20 - Singer 51WSV2 - Singer 143W2
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.