Unknown Chinese servo motor controller manual needed

[Einherj]

I also ran the original Chinese parameter table through chatGPT and it clarified that P-06 is most likely the number of automatic lock stitches at the start and end of sewing. This is desirable when doing bar tacking, etc.

[1hp]

you can remove pins from connectors without cutting the wires.

https://www.cycleterminal.com/terminal-extraction-procedure.html

[AlZilla]

Thanks, @Einherj. The more of this that can be collected in one place, the better we all are.

[Einherj]

9 hours ago, 1hp said:

you can remove pins from connectors without cutting the wires.

https://www.cycleterminal.com/terminal-extraction-procedure.html

I know. I didn't have a small enough tool handy at the time, but I had a soldering station.

I was testing the P-06 some more, and it seems it is actually a limiter for the maximum number of stitches the machine sews while holding down the pedal.
If I set it to 1 the machine does one stitch, if I set it to 4 the machine does four stitches, etc, no matter how long you push the pedal, that's the maximum number of stitches it does. You have to lift the pedal to do another round. This setting requires a needle position sensor, of course. When the setting is at 0, there is no limit.

[friquant]

1 hour ago, Einherj said:

I was testing the P-06 some more, and it seems it is actually a limiter for the maximum number of stitches the machine sews while holding down the pedal.

Ah that's cool.