how to edge bevel in corners?

[Daggrim]

I edge bevel my helmet frames, but there are lots of inside right angle corners which I can't get to. How do you do it? I've tried using my exacto, but it's easy to make an ugly corner that way.

Dag

[Tina]

  Daggrim said:

I edge bevel my helmet frames, but there are lots of inside right angle corners which I can't get to. How do you do it? I've tried using my exacto, but it's easy to make an ugly corner that way.

Dag

Hi,

I use a scalpel with blade number 20. I know it aint easy but...I angle the blade to just nip of enough of the edge and it seams to work fine and after burnishing you can't tell the difference.

[bruce johnson]

To end up with a flat bevel I use a small french edger. For a rounded edge I use a round bottom edger with the open toe design. I don't make a lot of totally square inside corners. I punch the corners with a small drive punch first, and then cut out from there. It makes it easy to get in there with a small dowel to slick that corner. The round bottom or bent tip edgers will go right around a corner punched with a pretty small drive punch.

[Bree]

Bevel everything prior to assembly.