M1911 Tuckable Iwb

[Deanimator]

Finished sewing and molding this afternoon. Actually finished my first roll of thread making this one.

It was TIGHT before I wet molded it, and that was with a Norinco with small sights! After the molding, my ball gun with Bomar sights fit perfectly.

I'll let it dry a day or two and then dye it.

The Eco Flo glue I used on the reinforcement ran a little. I wiped it up right away, but where it ran appears to repel water. I figure that'll affect the dye. Any suggestions?

Thanks.

[dirtclod]

You might be able to get the glue off with a eraser. I have a couple of times.

[Deanimator]

  On 8/9/2010 at 1:37 AM, dirtclod said:

You might be able to get the glue off with a eraser. I have a couple of times.

I didn't think of that. I'll give that a try before I resort to something like emery paper.

Thanks.

[steelhawk]

  On 8/9/2010 at 2:05 AM, Deanimator said:

I didn't think of that. I'll give that a try before I resort to something like emery paper.

Thanks.

I use an eraser remove rubber cement, one of the thick white ones, or an eraser pen with a long refillable eraser in it.

Edited August 9, 2010 by steelhawk