How I Braid Rawhide Hondas

[ct701996]

This is how i braid a rawhide honda, im not sure what you would call it, I will add more pics later

[ct701996]

These are the rest of the pics, i will load burner pics later

[ct701996]

I normally use rawhide burners on my rawhide hondas, but recently i have been using plastic burners, Plastic burners are really the way to go, you get the weight of a rawhide honda with the speed of a plastic burner, and when the honda gets wet it doesnt get so sticky and slow, please tell me whatcha think

[megabit]

:specool: :clapping:

Neat I like it. Isn't it hard to get the dowel through the center after the knots are tied?

[ct701996]

no its not too bad, i have a long tapered spike i use, and i usually can get it all the way through, then i take out the spike and put in my 3/8 plug, the spike is a little larger than 3/8 so i have to hurry and put in the plug but i can usually get it done. i think the knots look better if you tie them before you put the plug in

Edited March 22, 2011 by ct701996

[rgerbitz]

Total awsomeness. Thank you for taking the time to put this up. Where do you get the plastic burners?

Rob

[ct701996]

i bought them at my local feed store, i think some of the big chain stores like big r have them and i know buckaroobusinesses.com carries them

[ljensen]

Thanks for sharing your steps. It is great to see how many different people have.

On your initial loop, are you twisting the strands to make the loop section or did I miss something? Also I like the speed burner idea cause I dislike putting on the rawhide burners.

[ct701996]

right away i find the middle of the strings, then i do a slit braid right in the middle of them, you could also braid 4 strands in the middle

[Aggiebraider]

I like how you did the slit braid (or blood knot as some people know it) for the initial loop. I think that would close up a bit better than even doing the 4 strand braid since it is much flatter

CW