cowboy bill Report post Posted February 19, 2012 can i take a wood galvanized metal covered blank and tighten the bolt to get neck down to 2 1/2 in size from the standard 3 inches ?? thanks BILL Quote Share this post Link to post Share on other sites
harrington Report post Posted February 19, 2012 I have done it with a monel covered oak stirrup from Weber. Be sure to use a new pipe spacer 2 1/2" wide. It should work fine for your stirrup as well. Quote Share this post Link to post Share on other sites
Ben Report post Posted February 21, 2012 Cowboy B,ill I use a tubing cutter to cut the 3" spacer down to 2 5/8" . Once the bolt is tightened down cut off with a hacksaw and peen with hammer. Ben Quote Share this post Link to post Share on other sites
cowboy bill Report post Posted February 22, 2012 thanks for the reply, i figured i could do that but i never had that problem before. BILL Quote Share this post Link to post Share on other sites
