Members cowboy bill Posted February 19, 2012 Members Report Posted February 19, 2012 can i take a wood galvanized metal covered blank and tighten the bolt to get neck down to 2 1/2 in size from the standard 3 inches ?? thanks BILL Quote
Members harrington Posted February 19, 2012 Members Report Posted February 19, 2012 I have done it with a monel covered oak stirrup from Weber. Be sure to use a new pipe spacer 2 1/2" wide. It should work fine for your stirrup as well. Quote
Members Ben Posted February 21, 2012 Members Report Posted February 21, 2012 Cowboy B,ill I use a tubing cutter to cut the 3" spacer down to 2 5/8" . Once the bolt is tightened down cut off with a hacksaw and peen with hammer. Ben Quote
Members cowboy bill Posted February 22, 2012 Author Members Report Posted February 22, 2012 thanks for the reply, i figured i could do that but i never had that problem before. BILL Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.