srbonner Report post Posted May 10, 2012 The project I'm working on has some large panels that I used a x510 with a d439 for the border. I have another part that has some small corner pieces that I want to stamp also. The larger basket stamp and border seem like they are gonna be to big for the small area. Design wise, will it be OK to use a smaller basket and border instead of the larger ones? Just didn't know if it is OK to mix sizes. Thank you. Quote Share this post Link to post Share on other sites
electrathon Report post Posted May 10, 2012 Of course it is up to you. But if it was me, I would say it is OK as long as the stamps are the same , only a differant size. Quote Share this post Link to post Share on other sites
Glendon Report post Posted May 10, 2012 It's purely a design choice, so it's completely up to you. I could see it looking just fine. The nice thing about custom designs is that only you would ever know if it's technically a mistake or not. Quote Share this post Link to post Share on other sites
Zonker Report post Posted May 10, 2012 It's purely a design choice, so it's completely up to you. I could see it looking just fine. The nice thing about custom designs is that only you would ever know if it's technically a mistake or not. I agree. Hell most of what other people think is my most brilliant stuff was mistakes when I did them. Quote Share this post Link to post Share on other sites
srbonner Report post Posted May 10, 2012 Thanks guys. Just didnt want to get it done and say oops. I just knew the big stamp and border were gonna look real cluttered. Thanks again for the help. Quote Share this post Link to post Share on other sites
