MADMAX22 Posted July 20, 2008 Report Posted July 20, 2008 OK so anyone that has built some fender bibs what way did you attach them to the motorcycle. I understand you can bolt them down to the rear seat bolt holes however I dont want any buttons or bolts going thru my bib because Im gonna tool up a nice design on it and want to lace the edges. I can attach it under the the front seat but dont want it flapping in the wind if ya know what I mean. Thanks for any input Quote
MADMAX22 Posted July 21, 2008 Author Report Posted July 21, 2008 Well I think I figured it out. Since I dont want any bolts going thru my work, so I will attach it under the front seat at the back where the rear of the solt attaches to the fender. Then Ill install some of those magnets that are rare earth and come in coin looking stainless shapes. I dont know how many of those Ill need but it should keep the thing from flapping around and be easy to remove and install. I saw some other ones and they all seemed to either use velcro which is glued to the fender or they used 3m sticky tape. The velcro isnt a bad idea I just dont know if I want it glued to my fender or not. However if the magnets dont work then Ill go the velcro route. I doubt the sticky side would do anything to the paint. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.