SooperJake Report post Posted September 9, 2012 (edited) Will the LCP mag work in place of a Bodyguard Mag for molding? Jake Edited September 9, 2012 by SooperJake Quote Share this post Link to post Share on other sites
Shooter McGavin Report post Posted September 9, 2012 If they are both steel framed single stack 380 mags I would guess yes. There doesnt seem to be a lot of variation in sizes between magazines with the same build style and caliber. If someone can confirm my guess that would be awesome though. Quote Share this post Link to post Share on other sites
SooperJake Report post Posted September 10, 2012 Yes, it would be awesome if they would. Jake Quote Share this post Link to post Share on other sites
renegadelizard Report post Posted September 10, 2012 Yes, it would be awesome if they would. Jake Ive googled everywhere trying to come up with measurements for the bodyguard mag...no luck... Quote Share this post Link to post Share on other sites
03jesse41 Report post Posted September 11, 2012 Ive googled everywhere trying to come up with measurements for the bodyguard mag...no luck... My girlfriend has a bodyguard and I can get some measurements off of it on lunch if you still need the information. Quote Share this post Link to post Share on other sites
SooperJake Report post Posted September 12, 2012 (edited) Yes, Please. I want to make a holster and pouch for my Brother-in Law's birthday, so I don't want to ask him for the measurements. if the mags are way off, I need to order one with the blue gun. Jake My girlfriend has a bodyguard and I can get some measurements off of it on lunch if you still need the information. Edited September 12, 2012 by SooperJake Quote Share this post Link to post Share on other sites
03jesse41 Report post Posted September 18, 2012 Please forgive me I forgot to do this before my vacation. But here is the info. Width- 1.077" Thickness-0.437" Height-3.089"(from bullet tip to bottoming out on top edge of finger rest on mag) Hope this helps and isn't to late Quote Share this post Link to post Share on other sites
SooperJake Report post Posted September 18, 2012 Not too late and pretty near identical, although I'm eyeballing with a ruler vs. calipers. If I understand your length measure, the LCP is shorter, but I don't think that presents much worry. Thanks 03! Jake Please forgive me I forgot to do this before my vacation. But here is the info. Width- 1.077" Thickness-0.437" Height-3.089"(from bullet tip to bottoming out on top edge of finger rest on mag) Hope this helps and isn't to late Quote Share this post Link to post Share on other sites
03jesse41 Report post Posted September 18, 2012 You will be good to go then and no problem. Quote Share this post Link to post Share on other sites
