"screw" Line 24 Type Snaps

[J Hayes]

This is a Bianchi holster, I'll get you more later today. These are 8/32 screws and are stainless steel. Lift the spot YKK snaps. Don't skimp on your product.

Jeremy

[J Hayes]

I sandwich the T nuts between the layers. 8-32 x ¼ Tnut and 8-32x3/8 flat undercut machine screw both stainless steel. I clip a bit of the prongs off on the T nut and when I glue everything together I have plywood drilled for the t nut barrel and the clamp the heck outta them. The prongs of the t nut protrude every so slightly and tend to bite into the belt loop a bit which helps prevent them from turning I feel. The key to using the 8-32 is the undercut head, it sits a bit lower in the snap allowing plenty of room to not impede function of the snap. I personally feel 6-32 is a bit light for my comfort level.

Jeremy

Edited December 7, 2012 by J Hayes

[Blazin]

Thanks J for posting this, I've never seen those types of snaps. I have to figure out a way to snap really thick pieces of leather and this may be it.