drcharlemagne Report post Posted January 25, 2013 When I machine sew tight inside curves, like around the trigger on a moulded holster, the length of the foot interferes with staying tight to the edge. As a result I end up manually placing several stitches, eyeballing the stitch length, and handcranking. Is that the best strategy? any better ideas for tight inside curves with a machine? Quote Share this post Link to post Share on other sites
Anne Bonnys Locker Report post Posted January 25, 2013 Roller foot? Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted January 27, 2013 I switch to a right toe outside foot when I sew close to shaped parts of holsters. This way the outer foot does not hit the shaped leather. If the inside foot is too large in front, grind it down a bit. Quote Share this post Link to post Share on other sites
billymac814 Report post Posted January 28, 2013 I personally sew the holster together before doing the molding, that way its still flat or somewhat flat. There are times like repairing a holster or some other instances where you have to stitch right up next to something then I do as Wiz said. Quote Share this post Link to post Share on other sites
drcharlemagne Report post Posted January 28, 2013 Thanks for your input guys. Quote Share this post Link to post Share on other sites
