walletman Report post Posted August 26, 2008 hi still having problems can not do it i dont know wots going wrong instead of getting a arrowhead i am getting a dimond patten plz help many thanx bob Quote Share this post Link to post Share on other sites
Tina Report post Posted August 26, 2008 (edited) Hi, I dont know if this is what you're looking for but...:-) http://www.tandyleatherfactory.com/IMAGES/...olBdr-6-612.jpg ps. Check your messenger out, I did send you a better one there. Edited August 26, 2008 by Tina Quote Share this post Link to post Share on other sites
rdb Report post Posted August 26, 2008 In my little belt making tutorial, there's a few pix of that arrowhead design...maybe real life pix might help you out. http://leatherworker.net/forum/index.php?s...amp;#entry57694 It's really just a matter of a center line, and watching that the points meet right. (don't scratch the line as hard as I did, or you'll get that line down the middle after finishing goes on). The exact angle can be easier if you use the edge border line to match the backend of the stamp up with, after you place the front leg on the center line. I like to do both sides, rather than one side down the length first, it seems easier to match up for me that way. But with a little practice, you can figger the way you like. It takes me about 1/2 hour to do the whole design with camo down an entire belt blank...all pretty much free hand after the center line. Quote Share this post Link to post Share on other sites
