Using Nestsfoot Oil

[mato]

Guys i want to know when using nestsfoot oil to oil leather

do you apply to both furr and skin sides or just the skin ??

and how do you apply it i was just using a micro fiber cloth and rubbing it in

and one last question can it be used after using a sealer like eco flo sheen ?

[Harag]

I might be wrong as I'm new and also learning, and just finished some practice tooling, but I think the oil goes on before any painting/ dye/finish.

One thing I have read a lot is LET IT DRY FOR 24 HOURS at least before continuing.

[Cyberthrasher]

You'll want to apply it to the grain side (the side you tool) after tooling and before dying. Just a light coat. Sometimes you may want to put another light coat on after you dye, but I wouldn't worry about that yet until you're familiar with all the results. Also, keep in mind that if any part of your piece is to be left natural, the oil WILL darken it. During those times I just skip over that part of the leather. If the entire piece is natural, I just oil the back (flesh) side.

in regards to putting it on after a finish - it can be done, but keep in mind if your finish is properly applied your leather will be fairly well sealed. I usually apply a wax based conditioner at this point and let it sit over night. I use Resolene for a finish and the oils in my conditioner eventually seep through the finish. Again, i'd wait until you're more familiar with all the results.

[mato]

thanks guys a lot of useful info