Dawn N Report post Posted July 27, 2013 I am at a loss again. I was working with 277 thread and a 25 needle and my cobra was doing fine. I switched to 138 thread and 23 needle and the needle is shredding my thread. I think I purchased a machine over my skill level. Anyone know why it is doing this and how I can fix it? Thank you!! Quote Share this post Link to post Share on other sites
Dawn N Report post Posted July 28, 2013 Disregard...I fixed it. My needle was in wrong.... Quote Share this post Link to post Share on other sites
The Dawg Club Report post Posted July 28, 2013 Just a tip....which is sometimes the problem for me. If you feel any sharp edges around tip of needle besides the point. Keep a piece of sandpaper around to smooth it out. Sometimes the dremel is closer and I use that. Malik Quote Share this post Link to post Share on other sites
