sjstates Report post Posted July 30, 2013 When I was applying some RTC over my antique it picked up and smeared some of the antique where I don't want it. Is there a easy fix for this? Quote Share this post Link to post Share on other sites
Cyberthrasher Report post Posted July 30, 2013 Sometimes you can fix it if you clean it up immediately....... Whenever you apply finish over your antique, use light pressure and make sure you're not using an applicator that will go down into the tooling to pull the antique out. Also, make sure you're letting your antique dry long enough. Give it some time to cure and harden up a little bit so it doesn't pull out as easily. Quote Share this post Link to post Share on other sites
electrathon Report post Posted July 30, 2013 Try using tan kote over the antique and RTC under the antique. Aaron Quote Share this post Link to post Share on other sites
sjstates Report post Posted July 30, 2013 Thanks guys I appreciate the help Quote Share this post Link to post Share on other sites
