Thin End Points

[Boriqua]

I am doing a holster design for someone and I came up with the design attached. Here is my problem. If you look at the dark spots whick is all that will be stamped down they end in fine points. A swoop to a triangular point. I intended to stamp just those dark spaces down but now have trouble figuring out how to do those sharp points at the ends of the dark spots. I may be able to get my background stamp in there but was hoping for other suggestions. Anyone have other (better) ideas on how to pull it off? Thanks!!

Alex

[Wishful]

If i understand you correctly, I would use a104 or 888 backgrounders . Another alternative is to use a modeling spoon but you will not get a texture. Good luck.

Edited November 11, 2013 by Wishful

[Boriqua]

  On 11/11/2013 at 1:58 PM, Wishful said:

If i understand you correctly, I would use a104 or 888 backgrounders . Another alternative is to use a modeling spoon but you will not get a texture. Good luck.

Thank you so much!! The 104-2 is perfect.

Alex

[OdinUK]

I'd probably use a triangular bevel in the corners first before the background tools.