jmann8686 Report post Posted December 5, 2013 Hello all. I have an old CS osbourne and the anvil is toast. I ordered a new one but it is for the 155 punch. Mine is not a 155 it is there old one. The anvil is smaller then the one for the 155. Would anybody know where I might be able to find a replacment. The punch is still good and I don't have the funds to replace it with a 155. Any help would be nice. Thank you. Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted December 5, 2013 You can make one with a copper bolt if you can't locate one. http://www.copper-parts-components.com/product/Copper-Bolts-hex-Bolts-Hexagonal-head-Screws-fasteners.html You can drill and use a nut or drill and tap. You can even cement a couple of pennies together or use a piece of nylon if you need it right away. Quote Share this post Link to post Share on other sites
J Hayes Report post Posted December 6, 2013 (edited) Can you sand or file the anvil you ordered to fit? I wouldn't open the hole in the puch up to much though, fear of weakening the jaw. Just my thoughts Edited December 6, 2013 by J Hayes Quote Share this post Link to post Share on other sites
jmann8686 Report post Posted December 6, 2013 J hayes that was my thought I as well. I was just hoping to find one instead of trying to sand it down. and I didn't want to drill the hole out any bigger. Tree reaper- I never thought of trying to find a copper bolt. I will have to see if I could possible find one. Thanks. Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted December 6, 2013 You might not even have to drill it if you go with a 3/16 copper bolt. It looks like they're using a copper contact type rivet for the anvil. A electrical supply that deals in bus bars and other specialties might even stock that rivet. Quote Share this post Link to post Share on other sites
