biker55 Report post Posted August 17, 2014 Hello all again, am I correct to assume that a beveler is used to give depth to your carving? thanks again Quote Share this post Link to post Share on other sites
Chief31794 Report post Posted August 17, 2014 Yes, after cutting the lines with a Swivel Knife, then you bevel one side of the line or the other to give the carving depth. Chief Quote Share this post Link to post Share on other sites
biker55 Report post Posted August 17, 2014 thank you very much. now to buy a beveler! Quote Share this post Link to post Share on other sites
Jwalker Report post Posted September 13, 2014 perhaps theres a tandy leather factory store near you...they do classes Quote Share this post Link to post Share on other sites
