Members KGeorge Posted February 5, 2016 Members Report Posted February 5, 2016 I was wondering if anyone could share their process for tooling the gullet? I can't figure out a good way to do it. Would you tool it after cementing it in and while it's still cased on the saddle tree or fit it in let it dry and then take it out flatten it just enough to tool it then fit it back it permanently? Quote
Members kseidel Posted February 5, 2016 Members Report Posted February 5, 2016 If you want borders around the tooling, than it is best to tool it after it is installed. No need to stamp immediately, you can re wet and stamp it after the swell cover is installed and skirts are fit for border placement. If you don't need borders, than you can stamp it past the edges flat on the bench, and then install. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.